OBO Bettermann isCon BA 45 SW, Инструкции системы

Страница: 35 / 68

System instructions OBO isCon
®
EN | 35
Installing the isCon® system
Only for the light grey isCon
®
R ProPl 75 LGR conductor:
To connect the potential connection element, the light grey jacket in the
contact area must be removed before you push the cable into the air-
termination rod.
ATTENTION
Risk of damage!
The black, weakly conductive jacket may not be removed, as otherwise
the connection to the building's equipotential bonding can be interrupted.
In the case of the grey cable jacket, maintain a maximum cutting depth of
1.5 mm.
• Measure 1,500 mm from the bottom edge of the isCon
®
IN connect
connection element.
• Remove 50 mm of the grey cable jacket with a cable knife ("jokari
knife").
50 mm
50 mm
1,500 mm
> 1.5 mm
1.5 mm
Figure 32: Removing the light grey outer jacket
Note! The jacketing of the light grey isCon
®
conductor can be painted. It does
not possess any electrical properties which could be at risk from paint.
Assembling the air-termination rod
• Lay all three parts of the air-termination rod on the ground.
• From below, run the isCon
®
conductor through the retaining rod and
the middle rod.
Figure 33: Pushing the isCon ® conductor through the air-termination rod