Oasis RAPID PRO RP14, Инструкция по установке и эксплуатации

Страница: 11 / 44

Page 10 of 43
Safety
Installation, repair, or relocations should be completed by a fully qualified technician.
If not carried out correctly, several hazards, such as fire, electric shock, water
leakage, and injury, may occur.
This appliance is not intended for use by persons (including children) with reduced physical sensory or
mental capabilities, or lack of experience and knowledge, unless they have been given supervision or
instruction concerning use of the appliance by a person responsible for their safety.
•
A circuit protection device must be installed for the unit.
•
To avoid risk of electrical shock, the unit must have a good
power connection and earthing.
•
Before obtaining access to terminals all supply circuits must be
disconnected.
•
The unit is equipped with an over- load protection system. After
a stoppage, the unit will not start for at least 3 minutes.
•
Do not use any means to accelerate the defrosting process or
to clean other than those recommended by the manufacturer.
•
If installing in an enclosed area, the equipment should be kept
away from any sources of ignition. This includes items such as
open flames, operating gas appliances, or operating electric
heaters. Any refrigerant leakage can potentially result in a fire
hazard.
•
Do not pierce or burn the unit.
•
Be aware that refrigerants may not contain an odour.
•
If the supply cord is damaged, it must be replaced by the
manufacturer, a qualified service agent or similarly qualified
persons in order to avoid a risk.
•
This appliance must be installed in accordance with national
wiring regulations.
•
Avoid lifting the water unions when relocating the heat pump,
as doing so may cause damage to the titanium heat exchanger
inside the unit.
•
Avoid placing obstructions in front of the air inlet and outlet of
the heat pump