OAI 200 Series, Руководство по эксплуатации

Страница: 9 / 21

9
Installing the Microscope
1.
Unpack the microscope and assemble it according to the manufacturers
instructions supplied with the microscope. (There is a steel pin attached to the
back of the microscope mount. The center of the microscope focus range is
determined by the position of this pin and it has been properly installed at the
factory.)
2.
Insert the pin into the anodized shaft of the transport mechanism and tighten the
retaining bolt. (NOTE: The transport mechanism has been secured by tape, which
prevents movement of the Y stage and by a clamp on the bearing shaft below the
front of the transport stage. The clamp has a tag on it instructing the user to
remove it before operating the system. Remove the tape and the clamp.)
3.
Install eyepieces and objectives as appropriate.
Installing the Constant Intensity Controller
1.
Remove the Constant Intensity Controller from its packing.
2.
Connect the cables as shown in Figure 1 and the instructions in the Constant
Intensity Controller manual.
Preparing the Console
1.
Connect all vacuum, air, and nitrogen lines as shown in Figure 2. Turn on the air
and nitrogen and adjust your regulator to 60 PSI.
2.
The pressure for the Acculign functions (substrate lift and floating the ball seat)
have been adjusted at the factory assuming that 60 PSI have been provided. If
further adjustment is necessary; the adjustment valves are mounted on the bottom
side of the system's base plate.
3.
Check the safety and air interlock by raising the mask frame. There should be a
brief hiss of air exhausting. The mask frame will not rise if the alignment optics is
not in the full rear position and the interlock switch closed. This is to prevent the
mask from hitting the optics when raising.
4.
Check all electrical connections and plug in the main power line.