Nussbaum 4.40 ND, Инструкция по эксплуатации и документация

Страница: 21 / 64

Operating Instruction and Documentation
4.40 ND
- 21 -
• Adjust the columns with a water bubble.
• Bore holes to fix the dowels through the borings of the base plates. Clean holes with
pressure air. Put in safety dowels with washers in borings. The manufacturer
recommended safety dowels (e.g. from LIEBIG, Fischer or Hilti)
or equal dowels of another
manufacturer (with allowance) but observe their regulations! Before doweling check concrete
floor with quality C20/25 if the concrete floor goes to the top edge of the floor. In this
case the dowels have to be chosen according to picture 7 (Liebig anchor). If the ground is
covered with floor tiles, the dowels have to be chosen according to picture 8 (Liebig anchor).
• Tighten the dowels a little bit.
• Fasten the ropes at the top of the column.
pic. position of the ropes
• Check the position of the columns again.
• Connect the electrical power supply.
• Fasten the crossbeam at the rail one more time.
• Fill in the hydraulic oil. (Litre ? see chapter 3.)
In case of operation the automotive-lift, the chapter " Safety regulations” and
“Operating instruction” must be observed.
• Raise the lift until the supports can be removed. Press the button “lifting”
• Remove the supports.
• Lower the lift into the lowest position. (See chapter 5.2). Fasten the ratchet-strip.
• Raise the lift and hang the spring into ratchet strip. If necessary remove the sliding block of
the ratchet strip from the cross beam.
Rolle unten = role down
Rolle oben = role above