Nussbaum 4.40 ND, Инструкция по эксплуатации и документация

Страница: 17 / 64

Operating Instruction and Documentation
4.40 ND
- 17 -
• Examine the function and the condition off the sliding plates, the turntables and the fixing
pin.
• Version with wheel alignment set: Check the condition and function of the turn table and
sliding plates. Loosen the spring under the platform before removing the plates. Clean all
the parts. Before installing do not lubricate with fat. Because dirt can accumulate below
the plates and the movements impair. Use an oil Spray to oil the surface.
• Check all surfaces and repair if necessary.
• Damage to external surfaces, must be immediately repaired.
If theses repairs are not made immediately, permanent damage to the powder-coated
surface may result.
Repair and clean damaged areas with an abrasive paper (grain 120). After this is
complete, use a suitable paint (observe the RAL Number).
• Check the zinc surface and repair it with a suitable tool. Use abrasive paper (grain 280).
White rust can result from moisture laying in certain areas for long periods of time. Poor
aerating can also result in rust formation.
Rust may result from mechanical damage, wear, aggressive sediments (de-icing salt,
liquids) or insufficient cleaning.
Repair and clean these areas with abrasive paper (grain 280).
After this is complete, use a suitable paint (observe the RAL Number).
• The hydraulic oil has to be changed at least once a year. To change the oil, lower the lift
into its lowest position. Empty the oil tank and fill in clean oil, approx. (see chapter 3.) is
needed.
Use an ATF-Suffix hydraulic-oil (OEST Company ) if the ambient temperature is under 5
degrees centigrade. After filling, the hydraulic oil must be between the upper and lower
markings of the oil level gauge or 2 cm under the filler neck.
Remove the old oil according to the appropriate regulations.
Oil tank
Oil level gauge
Oil tank