Section 9
Service (Bottom)
Cocoon Aqua IR Hydration Pro System
38
6 Remove four (4) screws from the motor brackets. Remove the brackets to remove
the motor.
7 If replacing bed, remove cable from the nest to use in new bed.
8 Install motor and filter in reverse order.
9 When installing cover, make sure to apply silicone around the edge of the cover to
ensure watertight seal to the nest.
Name
Part Number
Motor+EMC filter
E4000-08
Vibration bed upper
E4000-89 (w/o motor)
Vibration bed lower
E4000-91 (w/o motor)
9.6 Hood Switch
1 Required tools: wrench 7mm
2 The hood switch is located between two (2) aluminum plates near right strut
(same side as the mixer). Switch is connected with small bolt to lower plate.
Name
Part Number
Hood switch
E4000-41
9.7 Supply Transformers
1 Small Transformer 220/11,5 V
The small transformer input is connected to 220V at the main circuit breaker.
The output is connected to terminal 37 +11.5V. Terminal 39 is ground in the
main power box. (See the 10.1 Electrical Connections table.)
2 Power Supply
The power supply input is connected to 220V at the main circuit breaker. The
output is connected to terminal 36 +15V. Terminal 38 +9V and terminal 39 are
ground. (See the 10.1 Electrical Connections table.)
Name
Part Number
Small transformer 220/11.5 V
E4000-101
Power supply 220/9.0/11.5/15V
E4000-102
The small green LED is on when the Power Supply works correctly. If the LED is not on,
reset the main circuit breaker. If the LED is still not on, change the fuse on the power
supply.
