nStor NexStor 4200F Series, Руководство пользователя

Страница: 57 / 174

Chapter 3 - Setup and Installation
Installing the Storage System into the Tower Stand
45
Installing the Storage System into the Tower Stand
1 Remove the enclosure from its shipping carton and inspect for obvious
damage. Place it on a flat surface to work from.
2
Remove the front bezel from the accessory box and store it in a location
where it will not be damaged. It will be installed later in the installation
procedures.
3
Remove the power supplies.
From the rear of the enclosure, remove each power supply by grasping its
handle and pressing in on the release latch with your thumb as you pull each
power supply from the enclosure. Repeat for the other power supply.
4
Remove the cooling fan module.
Place your fingers in the fan module handle and press with your thumb to
release the latch while pulling the module from the enclosure.
5 Remove the two rear mounting rails. Grasp and pull each rail from the
chassis.
NOTE:
The mounting rails were installed in the slots at the factory for the
purpose of shipping.
6 Remove the tower stand from its shipping carton and inspect for obvious
damage.
7
Locate the accessory kit in the tower shipping carton. It should contain eight
10-32 pan head screws and conversion instructions. (The enclosed
instructions are applicable to existing installation conversions.)
8
Rotate the enclosure chassis so that the power supply bays are on the top.
9
Carefully slide the enclosure chassis into the tower stand until it fits flush as
indicated in the illustration (A) on the following page.
10 Secure the top and bottom chassis ears to the tower stand using two each
10-32 pan head screws as indicated in the illustration (B) on the following
page.
11
Re-install the rear mounting rails into the slots at the rear of the chassis as
indicated in the illustration (C) on the following page.
4200F.book Page 45 Thursday, January 23, 2003 2:47 PM