NVR-3304POE, NVR-3308POE, NVR-3408POE-H2, NVR-3416
User’s manual ver.1.1.1
All rights reserved © AAT Holding S. A.
23
3.5. Startup configuration
Prior to using NVR for the first time, initial setup is strongly advised. Before you connect the IP
cameras to the NVR, please set up network and stream parameters of IP cameras using computer.
Note:
For suggested values for IP camera setting please refer to the “Cameras Compatibility Table”
available as separate file on novuscctv.com . If you will set wrong values some problems may appear:
the NVR cannot search the IP camera, the stream cannot be connected, the image is not fluent, the
image quality is bad and so on.
Set basic NVR configuration :
From the MAIN MENU
click SYSTEM icon
and then click on BASICAL
icon to set
following parameters :
SYSTEM TIME - set up correct time and date
DST
—
to set daylight saving functions
DATE FORMAT - Modify the date display format
DATE SEPARATOR - set the separator for date
TIME FORMAT - 12-hr or 24-hr display mode
TIME ZONE - set time zone
LANGUAGE - allow to select preferred language
VIDEO FORMAT- PAL or NTSC (required for using BNC video output)
DVR No.
–
set this value to be distinguishable from among several NVR with remote
control
AUTO LOGOUT - set standby time after user will be logout. (0
—
means no logout)
CHANNEL MODE - to select channel decoding configuration
3.5.1. Configure HDD
From the MAIN MENU select SYSTEM icon and click on STORAGE icon. Select check the
hard drive and press SET button to set HDD as read/write, read-only or redundancy mode. If it is
unformatted you have to select HDD and press FORMAT button to format HDD.
CAUTION: Hard disk format operation result in the loss of video data
NVR OPERATING
