18
5. *Add Salt to the Brine
Tank/Cabinet
Put 40 kgs of crystal water softener salt in
the brine tank. The unit will automatically
fill the water to the correct level when it
regenerates.
Start up and programming
complete. Unit is now
operational.
STARTUP INSTRUCTIONS
(CONTINUED)
4. Manually Regenerate the Valve
(Continued)
4a.
Open the inlet on the bypass valve slowly and allow water to enter the unit. (The outlet of the bypass should remain closed to prevent any fines or debris from entering the
plumbing system. Allow all air to escape from the unit before turning the water on fully then allow water to run until the drain water appears to be clear of any fines or color.
4b.
Plug in the valve. Allow the valve to continue its cycles until complete and back in service. Allow the valve to stay in each position for 2 - 3 minutes to purge air from the
system and the valve. Failure to properly purge the system may result in unsatisfactory performance. This process can be performed more than once if necessary to purge air
and color or fines from the system before finishing start up. Once the system is purged properly you can open the outlet of the bypass valve. Because your plumbing system
has been disturbed it is advisable to remove screens from faucets and flush all lines until clear.
See Plumbing System Clean-Up on page 19
.
4c.
The Valve is already programmed from factory. Please set up date and time of day and feedwater hardness and people as shown below:
(See page 17 for Key Pad
Configuration)
Calculating Compensated Hardness for Water where Iron or Manganese is Present
From your water analysis.
Iron x 4 = grains of hardness and or Manganese x 8 = grains of hardness. These numbers can be found on your water analysis report, and the equivalent grains of hardness should
be added to your total hardness number. The new sum of these numbers is the hardness to be entered during programming below.
EG
Iron = 0.5 ppm x 4 = 2.0 gpg
Mang = 0.3 x 8 = 2.4 gpg (always round up) = 3.0 gpg
Hardness = 15 gpg + 2.0 (compensated iron) + 3.0 (compensated manganese) =20 gpg
enter 20 as the hardness when programming below.
Iron ________ x 4 + Manganese x 8 ______ Hardness = Total Hardness ________
*
NOTE
Resin Cleaner
An approved resin cleaner
MUST be used on a regular
basis if your water supply
contains iron.
See page 22 - Res-Up®
Feeder Installation
Instructions
Press
SETTINGS
key
to advance to
TIME OF DAY. TIME OF DAY
will flash.
Press the Up or Down keys
to adjust the
TIME OF DAY
. Press & hold the Up or Down key
to quickly advance the hour & minutes. When desired
time is displayed press
SELECT
to advance to the
HARDNESS
setting.
HARDNESS
will flash.
Press the Up or Down keys
to adjust the
HARDNESS
(Min 1/Max 199). When desired hardness is displayed press
SELECT
to advance to the
PEOPLE
setting (Min 1/Max 9).
PEOPLE
will flash.
When desired number of people is displayed press
SELECT
to complete programming.
NOTE** All units are factory programmed for the correct size and regeneration cycle, alteration should only be done by a factory
trained technician or after consultation with one of our technical representatives if you have any questions please call:
1-877-288-9888
