12
O-ring
Plug
the
Riser
Tube
Upper
Cone
The riser
(distributor)
remains inside the
tank seated in the
depression at the
bottom
a)
Lube the bottom oring (picture
d
) and attach
the upper cone to the valve.
b)
Temporarily plug the open end of the riser
tube to ensure that no resin or gravel falls
down into the distribution. The riser (distrib-
utor) remains inside the tank seated in the
depression at the bottom. Plug tube with a
tape. Remove after media is loaded.
c)
Fill support bed first. The media will not
always spill down inside the tank and may
need to be swept inside.The large funnel
(sold separately makes filling the tank easier
and neater. (Or an empty 1 gallon or 4 liter
container with the bottom cut out makes a
good funnel.)
a
b
c
e
CAUTION:
Make sure the power cord of the valve doesn’t get caught
between the threads
Grease port Orings using
brush (not included) or
your finger (Make sure to
wear protective gloves)
D-Tube
Unscrew Spill Cap
Attach
Cone
d)
Lube the bottom Valve Orings with the grease supplied, Attach the Cone. Unscrew the spill cap. Carefully Slide the
D-Tube inside the Valve and Screw the Valve inside the Tank such that the power cord doesn’t get caught between
the valve and the tank.
d)
Unplug the riser tube, carefully position the valve over it and turn the valve into the threads in the fiberglass tank,
tightening securely into tank. Note: Ensure that the internal O-ring in the valve fits securely over the riser tube.
Silicone grease (part # 92360) or other food grade lubricant may be applied to the O-ring to ease installation of
the riser tube.
Resin
Support Bed
Gravel
Fill tank one quarter full of water to protect
distribution during gravel installation.
Place the media into the tank in the order
indicated above. Slowly and carefully add
the gravel support bed and the filtration
media leveling each layer as it is placed into
the tank.
d
PREPARATIONS
1.
Media Installation (When Necessary).
Models including and higher than 2 CF (Models 60, 90) of media are shipped with
separate media in pails or boxes. Models lower than 2 CF of media come loaded with media and this step can be skipped for new
installation.
CAUTION!
The unit should be
depressurized before
installing or replacing media
CAUTION!
Make sure that the
unit is de-pressurized
before conducting
this task.
CAUTION!
DO NOT use
petroleum based
lubricants as they
will cause swelling of
O-ring seals.
