Novell ZENWORKS LINUX MANAGEMENT 7.3 IR2, Руководство администратора

Страница: 450 / 684

450 Novell ZENworks 7.3 Linux Management Administration Guide
no
vd
ocx
(e
n)
7 Ja
nua
ry 201
0
8 Click Next to display the Summary page.
9 Review the configuration, then click one of the following:
Back: Allows you to make changes after reviewing the summary.
Next: Click to perform the following tasks before creating the bundle:
Š
Specify device assignments for this bundle
Š
Specify groups for this bundle
Continue with Section 30.6, “Assigning Unassigned Preboot Bundles,” on page 461 to assign
the bundle and complete the wizard.
Finish: Creates the kickstart bundle as configured per the settings listed on this Summary page.
This bundle is not assigned to any device or group after it is created, unless you click Next instead of
Finish to make that assignment.
IMPORTANT: If this Preboot bundle has been created on a management device inside the firewall
and you are assigning it to a device outside the firewall, port 8089 must be open both ways
(PUBLIC -> PRIVATE, and PUBLIC <- PRIVATE).
When any device assigned to the kickstart bundle boots, the bundle’s Red Hat installation work is
performed on the device.
30.4 Configuring ZENworks Script Bundles
A ZENworks Script bundle can contain any ZENworks script.
Using ZENworks Linux Management, you can install software using a bundle. Software included in
a bundle that is assigned directly is considered mandatory; the software is installed on all assigned
devices (the bundle is directly assigned to the devices, their groups, or their folders).
To configure a ZENworks Script bundle and assign devices to the bundle:
1 In the ZENworks Control Center, click the Bundles tab.
2
Click New > Bundle to start the Create New Bundle Wizard: