Novell ZENWORKS LINUX MANAGEMENT 7.3 IR2, Руководство администратора, Страница: 414 / 684

414 Novell ZENworks 7.3 Linux Management Administration Guide
no
vd
ocx
(e
n)
7 Ja
nua
ry 201
0
However, if the image contained in this bundle was not previously made from this device,
it receives the new ZENworks Control Center object that is defined in the image.
If you do not select this option and the device that this Preboot bundle is applied to has
been given a new hard drive to boot from, then a new ZENworks Control Center object is
created according to your ZENworks Management Zone configuration for non-registered
devices.
9 Click Next to display the Summary page.
10 Review the configuration, then click one of the following:
Back: Allows you to make changes after reviewing the summary.
Next: Click to perform the following tasks before creating the bundle:
Š
Specify device assignments for this bundle
Š
Specify groups for this bundle
Continue with Section 30.6, “Assigning Unassigned Preboot Bundles,” on page 461 to assign
the bundle and complete the wizard.
Finish: Creates the ZENworks Script bundle as configured per the settings listed on this
Summary page.
This bundle is not assigned to any device or group after it is created, unless you click Next instead of
Finish to make that assignment.
IMPORTANT: If this Preboot bundle has been created on a management device inside the firewall
and you are assigning it to a device outside the firewall, port 8089 must be open both ways
(PUBLIC -> PRIVATE, and PUBLIC <- PRIVATE).
When a device assigned to the ZENworks Image bundle boots, the bundle’s work is performed on
the device before its operating system starts.
Imaging a Device Using a Script
You can perform scripted imaging using the ZENworks Script bundle. Any imaging commands can
be entered for the script.
For example, if you want to mount a DVD and restore an image from it, you could enter something
similar to the following in the
Script text field in the Create New Preboot Bundle Wizard when
defining a ZENworks Script bundle:
echo "Please insert the DVD containing the image into the drive."
mount /dev/cdrom /mnt/cdrom
img rl /mnt/cdrom/myimagefile.zmg
umount /mnt/cdrom
eject /dev/cdrom
This example is a combination of automatic and manual tasks, where you define the bundle in the
ZENworks Control Center, assign it to the device, then when the device boots, it runs the bundle’s
script, prompting you to insert the DVD containing an image into the device’s DVD drive. The
script then runs the commands to restore the image on the device and ejects the DVD when finished.
For information on creating a ZENworks Script bundle, see Section 30.4, “Configuring ZENworks
Script Bundles,” on page 450 .