Nova Voyager, Руководство по эксплуатации

Страница: 21 / 29

123-1016-004
21
Motor Parameters
The DVR motor has built in motor characterizations (speed control profiles), each with slightly different PI controller coefficients and
performance characteristics:

SOFT - For light drilling. The controller will less aggressively add power to the motor to maintain speed

NORMAL (default) - Suitable for most work and is the default setting

HARD - For heavy drilling. The controller will more aggressively add power to the motor to maintain speed.
NOTE: The parameters Kprop and Kint cannot be saved into the EEPROM memory because it is based on the speed profile
parameter.
Parameter Description Default Value
Profile Motor speed control profile Normal
Kprop / Kint PI speed controller coefficients Varies
V kprop / V kint PI voltage controller coefficients 2000 / 9000
Vd DC Bus Motor phase DC bus voltage 360v
T Heatsink Temperature of the controller heatsink -
T Threshold Temperature threshold for current reduction 60ºC
Spd Err Difference between SET and RUN speed -
WARNING! Extreme changes to these parameters can result in undesirable and
potentially unsafe motor behavior. Call the NOVA Customer Care Center if you have any
questions on what effects your changes will make.
Set Password
This setting allows the drill press to be locked upon startup, requiring a password to access or run it. If the password is forgotten,
performing a factory reset will clear the password.
Upgrade FW (Firmware)
The HMI plays an important role in the control and functionality of the NOVA Voyager DVR Drill Press, and the HMI firmware version
controls the features and performance of the drill press. The firmware version of the HMI can be upgraded via USB cable accessory
and a PC with internet access. Be sure to check
www.teknatool.com periodically for firmware upgrades for your machine, which may
allow new features or software improvements that could enhance the performance of the drill press.
Email service@Teknatool.com for firmware update software and procedure.
Version Info
The current version of the HMI and the main control board can be displayed on the LCD screen.