Nova Voyager, Руководство по эксплуатации

Страница: 8 / 29

123-1016-004
8
SETTING UP YOUR WORKSHOP
Workshop Requirements
Consideration Recommendation
Drill Press location Locate the NOVA Voyager DVR Drill Press close to a power source in an area with good
lighting. Leave enough clearance on all sides of the drill press, and be sure to allow for
clearance when the table is swiveled. Other machines in your shop should not interfere
with the operation of the drill press.
Lighting Your shop should have adequate lighting. The work area of the drill press should be well
lit; there should not be shadows cast on your work. If possible, locate near a window. A
portable spotlight may be helpful.
Electrical The NOVA Voyager DVR Drill Press requires the appropriate power outlet nearby to
power the motor. Wiring and outlets should adhere to local electrical codes. If in doubt,
seek advice from an electrician. Minimize use of extension cords. See "Connecting to
Power" section for extension cord and surge protector requirements.
Ventilation Your shop should be adequately ventilated. The degree of ventilation needed will vary
based on the size of the shop and the amount of work done. The use of dust collectors
and filters will minimize risks to your health.
ASSEMBLING THE NOVA VOYAGER DVR DRILL PRESS
Unpacking and Preparing the Drill Press
1. Open shipping container, remove all components and set aside shipping materials. Keep all materials until drill press is
assembled and ensured to be operational.
2. Arrange all components on the ground to prepare for order of assembly from bottom to top of drill press, making sure to
use a protective layer to prevent the press from scratches and other damage.
Assembling the Column to the Base
3. Place the base in the desired location of the drill press, making sure to put it on a level floor. It can be secured to the floor
with lag screws (not provided) through the four corner holes in the base.
NOTE: Do not use a mobile base with this machine.
4. Align the column holes with those in the base, and thread the 4 included hex cap bolts onto the base with a 17mm wrench.
Tighten firmly.
Figure 2 - The assembled column on the base
WARNING!
Seek help when moving the NOVA Voyager DVR Drill Press and its heavier components to help
avoid risk of injury. Read and understand the contents of this manual and recommended procedures before
attempting to assemble or operate the drill press or its parts.
DO NOT CONNECT POWER ON DRILL PRESS UNTIL FULLY ASSEMBLED.