Nova Voyager, Руководство по эксплуатации

Страница: 9 / 29

123-1016-004
9
Mounting the Table Bracket and Rack
5. Insert the shaft of the worm through the table bracket from the inside as shown below, while mating the worm threads
with the preinstalled gear. Make sure to insert fully so the maximum shaft is exposed for later steps.
6. Insert the rack into the table bracket as shown below, mating the rack teeth with the worm gear. Pay attention to the teeth
angle with respect to the table bracket orientation. Position the bracket partway on the rack.
Figure 3 - Mounting the table bracket and rack 1/2
7. Slide the rack and bracket assembly down over the column and insert the bottom of the rack into the mating groove in the
sleeve on the bottom of the column.
8. Slide the top collar down and over the rack, ensuring that the grooved end of the collar is on the bottom to properly guide
the rack around the column (see below). Tighten set screw to secure in place.
Figure 4 - Mounting the table bracket and rack 2/2
Mounting the Headstock
Caution!
Be sure to use proper lifting technique to avoid injury or damage to the drill press. Be sure to plan
the method of attaching the headstock to the column before lifting. Only lift the headstock by the casting to
avoid damaging more fragile components. Applying lubrication to the column will ease the installation.