Nova Voyager, Руководство по эксплуатации

Страница: 16 / 29

123-1016-004
16
Positioning the Table
The table height and rotational position can be adjusted using the handle on the column:
1. Loosen the locking handle on the rear of the table bracket.
NOTE: It is important to unlock this handle before adjusting the table
2. Rotate the crank handle attached to the rack to raise/lower the table to desired height.
3. Swing the table about the column to the desired position.
4. Retighten the locking handle, and ensure table is securely locked in place before drilling.
Tilting the Table
To tilt the table:
1. Loosen the bolt underneath the table using included 27mm closed end wrench.
2. Loosen set screw underneath the previous bolt using 5mm Allen key.
3. Tilt table to desired angle.
4. Retighten bolt and set screw, and ensure table is securely locked in place before drilling.
Quill Lock
1. To lock the quill at a certain depth, pull the quill lever down to the desired level and turn the quill lock handle clockwise and
tighten firmly.
Figure 10 - Quill lock
2. If the quill lock handle is not fully tightened when it reaches its limit:
a. Pull the handle out along the screw so it freely rotates
b. Rotate back counter-clockwise
c. Set handle fully back down in place on screw
d. Tighten further until snug and quill is locked in place
Using the Mechanical Depth Stop
1. Press the button on the front of the quick release nut to quickly change the height of the nut.
2. For fine adjustment of the height, the nut can be rotated along the threads.