Maintenance Instructions
78
4.10.3 Front Headlights
The position of combined headlights is shown in Figure 4-24.
Figure 4-24 Combined Front Head Lamp Position
4.10.4 Taillight Assembly
The position of the rear lamp and tail lamp assembly (steering, position
and braking) is shown in Figure 4-25.
Figure 4-25 Taillight Assembly and Position
4.10.5 Headlight Illumination Intensity Distribution
As Figure 4-26 shows, the curve of the illlumination intensity distribution is
applicable to right-side traveling. If necessary, check and adjust the
illumination intensity distribution for the headlilghts.
Figure 4-26
Head Lamp
Illumination Intensity Distribution
The procedure is as follows
：
1.
Check the tire pressure and make sure that it meet the requirements.
2.
Place the (empty-load) tractor on a level plane, facing a smooth wall.
3.
Place two ―
﹢
‖ signs on the wall corresponding to head lamp central line:
●
Turn on the low beam light switch when the tractor is at distance of 5m from the wall.
●
The reference point (P-P) is located at 5cm under the ―Cross‖ mark on the wall.
●
Turn the adjusting nut of the headlight to regulate its distribution curve.
