Operation Description
43
Figure 2-50 Rear Window
1. Handle 2. Air Spring
2.17.7 Cab Rear Window
The tractor cab rear window is a semi-automatic upward
Opening type. There are two opening positions;
normal and maximum.
●
Normal Position
: Rotate the handle (1). When the front part
of the handle protrudes, push the handle until the bulge on the rear
of the handle reaches the slot. Rotate the handle (1) allowing the
bulge to slide into the slot. When this is done, the rear window can Figure 2-49 Rear Window Diagram
be opened and kept at a certain angle.
When closing, operate in the reverse order.
Maximum Position
: Place the handle (1) so that the front of the handle slides out. Once the handle is in
position, push the handle outside until the pulling force of the air spring (2) is overcome.
The gas spring (2) immediately changes to pushing
from pulling.
The rear window can be opened automatically to the
maximum position. When closing, the handle should be
pulled inwards, resisting the pushing force of the air spring
(2) The air spring (2) will change to pushing from pulling.
The rear window automatically closes when you turn the
handle. Once closed, slide the bulge in to the slot and in to the
locked position.
2.17.8
Driver’s Cab HVAC
There are two air outlets installed in cabs with HVAC (heating, ventilation, air conditioning).
The cover plate at the air outlet can be used to adjust the airflow and direction of the air. These controls
are located on the left side of the air conditioner.
The air conditioner control panel has the following controls:
max. opening angle
for rear window
