Setting Up the Auto Increment Mode
When operating in the Auto Increment Mode, the controller uses the data stored in the memory cells to automatically
adjust its settings over time or as dispense cycles are initiated, thus compensating for fluid viscosity changes. Refer
to “Entering Memory Cell Settings” to set up memory cells.
NOTE:
For an example of how the Auto Increment mode works, refer to “Auto Increment Mode Example” on the
next page.
1. On the MAIN screen, press F2.
2. Press ENTER to select AUTO INCREMENT MODE.
3. Press ENTER until the desired Auto Increment Mode is selected. Refer to the “AUTO INCREMENT MODE
Parameters” table for an explanation of each
parameter.
4. Press the down ARROW key to highlight AI SYNC.
5. Press ENTER until the desired channel is selected.
Refer to the “AUTO INCREMENT MODE Parameters”
table for an explanation of each parameter.
6. Press F2 to save the change and return to the MAIN
MENU.
7. Press F2 again to return to the MAIN screen.
To cancel changes at
any time and return
to the MAIN MENU,
press F3.
Setup (continued)
VM9000 Controller Key Legend
INCREASE (+) key
DECREASE (-) key
ENTER key
DISPENSE key
ARROW keys
,
ENABLE/DISABLE key
ValveMate 9000 Controller
41
www.nordsonefd.com [email protected]
800-556-3484 Sales and service of Nordson EFD dispensing systems are available worldwide.