Nordco Trailblazer BC60, Руководство по эксплуатации и обслуживанию, Страница: 46 / 72

BC 60 "Trailblazer" Brushcutter
MAINTENANCE
AUGUST/2012 (49458202/8203)
Section 3-1
MAINTENANCE AND SERVICE
REQUESTING ASSISTANCE
If you have any questions regarding maintenance and
service on this machine, please call your local Nordco
Representative or:
Nordco Service Manager
(414) 769-4603 (Wisconsin)
1-800-445-9258 (USA and Canada)
LUBRICATION AND MAINTENANCE
The following are suggested notes and guidelines
when performing maintenance on this machine.:
1.
Always make certain that the engine has
been turned off and the battery disconnect
has been turned to the OFF position before
performing maintenance on this machine.
2.
NEVER clean, adjust, repair, or lubricate the
machine while it is running unless specifically
required and providing all necessary
precautions have been taken.
3.
When performing maintenance on the
brakes, exercise caution if the spring brake is
to be disassembled. Follow the brake
manufacturer’s instructions on the outside of
the canister before attempting to disassemble
the brake housing. The springs in the brake
chamber are under tremendous compression.
4.
Use caution when draining hot fluids from the
machine. Splashing hot fluid can cause
serious burns.
5.
Never open the engine radiator cap while
engine coolant is hot.
6.
NEVER attempt to work under the machine
while it is raised on the turntable unless
special support blocks provided by Nordco
are utilized.
7.
Always ensure that all lubricating oils, fluids,
and filters are clean and maintained as
outlined in this section. It is important that
lubrication is performed at the time intervals
stated, or else machine damage could occur.
8.
Always ensure that the engine radiator and oil
cooler are kept clean and free of debris. Also
ensure that the cooling fins are in good shape
and not bent over.
9.
Always ensure that the pump suction lines
and ball valves are open and not blocked,
closed or collapsed.
10.
Do not position booms more than two feet
above storage cradle when performing
maintenance on the booms. This will prevent
damage to the swing cylinders.
11.
Do not use head rotate function to clear
cutterhead of debris. Best technique for
cleaning cutterheads is by hand,
after
shutting down machine, turning the
battery disconnect to the OFF position,
and cracking the hoses at the cutter
motors.
12. Boom swing cylinder speed is factory set.
Adjustments without prior approval from
Nordco will void warranty.
13.
Cutter blades that are installed too loosely
may become fractured and will cause
noticeable vibration during working
operations. Torque to requirements specified
in the Quadco Manual, located behind the
OTHER tab in this Manual.
14.
Before starting the machine, inspect it for
obvious defects and correct any problems
discovered.
15.
Inspect brake shoes for ice, and remove if
present, before operation of the machine. If
ice is allowed to build up on brake shoes,
braking efficiency is greatly reduced.
16.
Do not stand under cutterheads to perform
maintenance.
17.
Replace glass in cab if nicks or damages
occur to the outside.