Nordco Trailblazer BC60, Руководство по эксплуатации и обслуживанию

Страница: 17 / 72

BC 60 "Trailblazer" Brushcutter
PRE-OPERATION
DEC/2012 (49458202/8203)
Section 2-3
Figure 3-1. Front Console
Engine/Pump Controls and Gauges
John Deere Engines Only
INSTRUMENT OR
CONTROL
FUNCTIONAL DESCRIPTION
FUEL GAUGE
Measures the level of diesel fuel in the fuel tank. Do not allow to go into the red zone.
AIR PRESSURE
GAUGE
Measures air system pressure. Normal reading is 105 to 120 psi.
SPEEDOMETER Indicates travel speed of machine in both kilometers and miles per hour.
IGNITION SWITCH The electrical system is energized by turning the switch (or optional key) to the right.
Electrical power is cut off and the engine will stop when the key is turned to the full left
or vertical (OFF) position.
When starting engine, make certain hydraulic pump switch is in the OFF position
ALARM
Buzzer sounds on low air pressure, low oil pressure, and high coolant temperature.
ENGINE SPEED
SWITCH
Momentary switch used during work, travel, and shutdown. Hold switch in position until
desired engine RPM has been reached and then release switch.
PUMP SWITCH Turns pump ON or OFF. Engine will not start if the switch is in the ON position. This
is done to reduce engine load during starting.
If idling for more than 30 minutes, turn pump OFF to prevent overheating of hydraulic
oil.
SHUTDOWN
OVERRIDE SWITCH
Overrides engine shutdown for EMERGENCY travel purposes.
Once pressed, engine shutdown is delayed for 30 seconds. This switch should only
be used in emergency situations where track movement is needed. Continual override
of engine may cause permanent engine damage.
For use in emergency situations only, when machine must be moved despite engine
problems. The engine is NOT protected from low oil pressure or high coolant
temperature damage in this mode.
REVERSIBLE FAN Two position switch. AUTO or OFF. Must be in the OFF position when using the
snap-on winterfront on the engine. When in the AUTO position, the fan will cycle in a
certain direction for a timed amount before switching to reverse.
MURPHY DIAGNOSTIC
DISPLAY
See Next Page for more details. Refer to engine manual for error codes.
SHUTDOWN
OVERRIDE