Nordco Trailblazer BC60, Руководство по эксплуатации и обслуживанию

Страница: 38 / 72

PRE-OPERATION
BC 60 "Trailblazer" Brushcutter
Section 2-24
DEC/2012 (49458202/8203)
MACHINE STARTUP
EXHAUST EMISSIONS CAUSED BY THE USE OF THIS MACHINE MAY CAUSE CANCER, BIRTH
DEFECTS OR OTHER REPRODUCTIVE HARM IF INHALED.
BEFORE STARTING A NEW OR OVERHAULED ENGINE THAT HAS BEEN IN STORAGE, CONSULT
THE ENGINE MANUFACTURERS MANUAL FOR INITIAL START INSTRUCTIONS. FAILURE TO
FOLLOW THOSE INSTRUCTIONS CAN RESULT IN SERIOUS ENGINE DAMAGE.
Engine Operation
1.
Check engine oil level, engine coolant level, fuel oil level, and hydraulic oil level before attempting to start
engine.
2.
Ensure that pump suction line gate valves are fully open.
3. Make certain that the implement pump switch is in the OFF position.
4.
Ensure that parking brake is applied, EDC is in NEUTRAL position, and transmission is in 1st Gear.
5. Pull out Emergency Stop button.
6.
Set battery disconnect switch to ON position.
7. Turn ignition switch clockwise and hold until engine starts.
8. Press engine speed switch up once to rev up engine.
9.
Allow engine to idle until it warms up, then bring engine slowly to full rpm by pressing engine speed rocker
switch UP until the desired RPM's have been reached.
10. Perform the startup check on the next page.