NorAM 65E Turbo Motor Grader, Руководство по обслуживанию

Страница: 296 / 830

R e p a i r M a n u a l
Corporate Division
Off-Road Driveline Technology
and Axle Systems
5871 146 002 10/1
Figure 1
10. Installation of input shaft, output shaft and
clutches
If the suction tube (1) in the housing front part is to be replaced,
it is imperative to use the ZF special tool (rolling tool) for
assembly. Then fix the tube with cylindrical screw (2).
Tightening torque (M8/8.8x12) ............... M
A
= 23 Nm
(S) Rolling tool 5870 600 003
(S) Rolling tool 5870 600 005
(S) Lubricant 5870 451 006
Mount O-rings 22x3 into the annular groove of the oil tubes (1
and 2) and oil them.
Then insert tubes into the housing front part and fix them by
means of cylindrical screws (3).
Tightening torque (M8/8.8x12) ............... M
A
= 23 Nm
Figure 2
Mount screw plug (1) with new O-ring.
Screw plug: M38x1.5
O-ring: 35x2
Tightening torque ……................. M
A
= 140 Nm
Figure 3
The spare parts service supplies the lubricating oil tubes (1
and 2) only as a complete package with the housing rear part.
Single parts delivery upon request only!
Assembly is only possible with the ZF special tool!
(See also Figure 1).
(S) Rolling tool 5870 600 006
(S) Lubricant 5870 451 006
Figure 4
1
2
3
3
3
3
1
3
2
1
2
1