NKT Photonics Koheras BOOSTIK, Руководство по эксплуатации продукта

Страница: 16 / 68

Front and rear panels
16
Variants
Three different BOOSTIK variants are available, characterized by their output power
and center wavelength. Their specific characteristics can be seen in
Table 1 below.
Table 1 BOOSTIK variants and their characteristics
Front and rear panels
Front panel
The BOOSTIK front panel shown in Figure 2 includes optical output and input fiber
connectors and status LEDs. The output fiber and connector is fitted at the factory as
listed in
Table 1 above and the input fiber connector is a threaded E2000 FC/APC
connector that receives the optical output from a BASIK seed laser.
The status LEDs on the front panel indicate the following states:
•
Power – the supply voltage status
•
Interlock – interlock circuit open/closed (not OK/OK)
•
Emission – the laser emission status (enabled or disabled)
•
Status – the module stability status
For more information on the LEDs see “Status LEDs” on page 20 .
Variant: 2 W @ 1550 nm 200 mW @ 1550 nm 200 mW @ 1064 nm
Compatible Koheras seed laser(s) E15, X15,C5 E15, X15,C5 Y10
Operation mode
CW
i
i. Continuous Wave - inherently single frequency
CW
i
CW
i
Operating wavelength [nm] 1545 to 1565 1545 to 1565 1060 to 1075
Input power [mW] 1 to 50 10 to 50 10 to 50
Output power [mW] 2000 200 200
Output power tunability [%] 10 to 100 10 to 100 10 to 100
Polarization
PM
ii
or SM
iii
ii. Polarization Maintaining
iii. Singe Mode
PM
ii
PM
ii
Input and output optical
termination
FC/APC
iv
iv. Optional E2000 – output connector only
FC/APC
iv
FC/APC
iv
Output fiber type PM1550 or SMF28 PM1550 PM980
2