NKT Photonics Koheras BOOSTIK, Руководство по эксплуатации продукта

Страница: 57 / 68

57
C Electrical interface pinout
Figure 42 C/3 electrical interface pins
Table 13 C/3 electrical interface pin descriptions
C
B
A
10 9 8 7 6 5 4 3 2 1
30 pin DIN41612 male C/3 type
Pin # Signal Description
A1 Module OK Low: module enable low OR module power low
High: module power high
A2 RS485- Negative/inverted RS485 differential data signal
A3 Interlock loop+ Positive connection of interlock loop. Should be connected to Interlock loop- (pin no. 4) to enable
emission from the system.
A4 Interlock loop- Negative connection of interlock loop. Should be connected to Interlock loop+ (pin no. 3) to enable
emission from the system.
A9 N/C
A10 N/C
B1 Service NKTP Technical Support
B2 Service NKTP Technical Support
B3 Service NKTP Technical Support
B4 N/C
B9 AGND Analog ground for amplitude and wavelength modulation signals.
B10 AGND Analog ground for amplitude and wavelength modulation signals.
C1 Emission Collector output with internal 240 Ω resistor in series. The output is high when the amplifier emission
is ON. An LED anode can be connected directly to this pin and the Cathode to GND to indicate
emission externally.
C2 RS485 Positive/non-inverted RS485 differential data signal
C3 Enable Logic input that permits emission when a high (5V) i is applied. During emission if Enable is set low,
emission is shut off.
C4 Enable logic input Logic input that permits emission when a high is applied. If during emission the input is set low,
emission is shut off. This control input is for personal safety and is designed with redundancy within
the module.
C9 N/C
C10 N/C
A5, A6,
B5, B6,
C5, C6 GND 0 volt / ground
A7, A8,
B7, B8,
C7, C8 12V 12 volt supply voltage for the module.