NKT Photonics Koheras BOOSTIK, Руководство по эксплуатации продукта

Страница: 20 / 68

Front and rear panels
20
Status LEDs
The front panel houses four status LEDs that behave as described in Table 2 . The
LEDs are located at the center of the front panel near its top edge as shown in
Figure 5 .
Figure 5 Status LEDs
Table 2 Status LEDs
Note: D
O NOT OPERATE
the laser until you are familiar with the controls and have taken
all precautions necessary as described in the applicable document below:
Koheras BOOSTIK 2 W Laser Safety, Handling and Regulatory Information .
Koheras BOOSTIK 200 mW Laser Safety, Handling and Regulatory Information .
Emission
Interlock
Status
Power
LED Name Condition Description
Power ON Green DC Voltage at the DC power input pins is OK.
ON Red DC voltage at the DC power input pins is too low.
Flashing Amber The module is transmitting data.
OFF No DC power at the module power input pins.
Emission
ON Red Laser amplifier emission is ON.
OFF Laser amplifier emission is OFF.
Status ON Green Output power OK
ON Amber Module ready
Interlock ON Green The interlock status is OK – the door circuit is
closed and energized.
ON Red The interlock status is Not OK – the door circuit is
open or not energized.