User manual – Glass Clock Design #3
rev 1.2
4 Unpacking and setting up the Clock
Carefully unpack the clock from the box. The box should contain a wall plug-in
power supply, two clear acrylic end plates and the clock itself.
The power supply plugs into the wall outlet. The other end plugs into the clocks
power input jack.
When powered up for the first time, the clock will go through the self test
checkout. This checkout will set all the digits to '9', and each digit (starting with
the leftmost digit) will count down from '9' to '0'. When this is complete the
display will read “00 00 00”. Then each digit will go blank one at a time starting
with the leftmost digit. This completes the self test.
The clock has to buttons. On the left is a black function button, and on the right is
a red mode button.
At this point, the clock should show “0 00 00” with the leftmost digits (hours)
blinking. It is now in the time/date set mode. There is no need to press the right
mode button to enter the time set mode. Go to the next section, “Setting the
clock”. Note: Due to the time save function of the clock, if it was disconnected
from power less than an hour ago, it will not enter the time set mode – it will
show the current time.
Page 7 of 27
Illustration 3: Side View, Right
Illustration 2: Side View, Left