User manual – Glass Clock Design #3
rev 1.2
5.3.2
Setting the time – minutes
When the minutes (middle) digits are blinking, the minutes value can
be changed.
The black function button (left side) will change the minute value
when pressed. Holding the function button on will quickly cycle
through the minutes (0-59).
After the hours are set correctly, momentarily press the red mode
button (right side). At this point, all the digits
(Hours:Minutes:Seconds) will flash once a second. Pressing the mode
button again will update the time to the new settings. Note: The
seconds value will be reset to '00' when the time is set.
Now that the time is set, the clock will go to the set date mode.
5.4 Set date mode
When the clock is in the set date mode, the current date will be
displayed with the days (2 leftmost digits) blinking. The colons will
both be off.
If not in the date set mode, see the “Setting the time and date”
section. Before the date can be set, the time must be set. Note: If only
the date needs to be set, enter time set mode, and press the red mode
button to go through the hours, minutes until the date mode appears.
The time will not change.
To cancel setting the date value at any point, press and hold the red
mode button until the display goes blank. This will cancel setting the
date. When the mode button is released, the clock will go back to the
normal display. The old date value will be used.
Page 10 of 27