Youshiko YC9418 RC Projection clock
One Step Automatic Set Up:
Connect Clock with power supply and insert required battery or
activate the backup battery, and then insert batteries in outdoor sensor
and make sure it’s on CH1, and press reset button , then wait and don’t
do anything , for Projection Clock to
self set automatically
by MSF
Radio control system, within few minutes to few hours or maximum by
05:00 am, depending on the signal or your location. (After this you
never have to do anything, In some cases it may take up to 24H to self
set everything.
Automatic time change for Spring & Autumn and automatic time
checks, This also can take up to 24H to self set the time.
Keep the Clock display unit well away from TV / Computer / Wi-Fi Hub
/ Mobile phones etc to avoid any interference .
Please Note Before Using:
Every time Clock look for Radio control signal projection clock screen & projection time turns off for few minutes.
1. If the projection clock screen & projection time turns off when you turn the projection clock on, it's because it begins to
calibrate time automatically based on local radio-controlled time, not because it's faulty. The screen will light up after it
finish the auto time-calibration.
2 . The loudness of alarm sound or ringtone cannot be adjusted.
