Operation and Maintenance Manual
Second Edition
A Brand of Niuli
4
MAXITON GTJZ
Do not
place ladders or scaffolds in the platform or against any part
of this machine.
Do not modify or alter an aerial work platform. Mounting
attachments for holding tools or other materials onto the
platform, toe boards or guard rail system can increase the
weight in the platform and the surface area of the platform
or the load.
Do not replace items critical to machine stability with items
of different weight or specification.
Do not use the machine on a moving or mobile surface or
vehicle.
Be sure all tires are in good condition, castle nuts are
properly tightened and cotter pins are properly installed.
Do not use batteries that weigh less than the original
equipment. Batteries are used as counterweight and are
critical to machine stability.
Each battery must weigh 62 pounds / 28kg.
Do not use the machine as a crane.
Do not push the machine or other objects with the platform.
Do not contact adjacent structures with the platform.
Do not tie the platform to adjacent structures.
Do not place loads outside the platform perimeter.
Do not operate the machine with the chassis trays open.
Do not use the platform controls to free a platform that is
caught, snagged or otherwise prevented from normal
motion by an adjacent structure. All personnel must be
removed from the platform before attempting to free the
platform using the ground controls.
Fall Hazards
Occupants should wear a safety
belt or harness and comply with
applicable
governmental
regulations.Attach the lanyard to
the anchor provided in the
platform. Do not sit, stand or
climb on the Platform guard rails.
Maintain a firm footing on the
platform floor at all times.
Do not climb down from the platform when
raised.
Keep the platform floor clear of debris.
Attach the platform entry chain or close the entry
gate before operating.
Do not operate the machine unless the guard rails
are properly installed and the entry is secured for
operation.
。
Collision Hazards
Be aware of limited sight distance and blind spots
when driving or operating.
Be aware of the extended
platform position when
moving the machine.
The machine must be on a
level surface or secured before releasing the
brakes.
It is recommended that operators wear an
approved hard hat when operating the machine.
Check the work area for overhead obstructions or
other possible hazards.
