Operation and Maintenance Manual
Second Edition
18
Maxiton GTJZ
machine damage or malfunction before operating the
machine.
Before Repairs Start:
➢
Read, understand and obey the safety rules
and operating instructions in the GTJZ06/08/10 /12/14
Operator’s Manual.
➢
Be sure that all necessary tools and parts are
available and ready for use.
➢
Read each procedure completely and adhere
to the instructions. Attempting shortcuts may produce
hazardous conditions.
Unless otherwise specified,
perform each repair procedure with the machine in the
following configuration:
· Machine parked on a flat, level surface
· Boom in the stowed position
· Turntable rotated with the boom between the circle-
end wheels
· Turntable secured with the turntable rotation lock
pin · Key switch in the OFF position with the key
removed
· Welder disconnected from the machine
· Wheels chocked
Repair Procedures
Most of the procedures in this section should
only be performed by a trained service
professional in a suitably equipped workshop.
Select the
appropriate repair procedure after troubleshooting
the problem.
Perform the disassembly procedures to the point
where repairs can be completed. Then to re-
assemble, perform the disassembly steps in reverse
order.
Symbols Legend
Safety alert symbol!used to alert personnel to
potential personal injury hazards. Obey all safety
messages that follow this symbol to avoid possible
injury or death.
Red! Used to indicate the
presence of an imminently hazardous situation
which,if not avoided, will result in death or serious
injury.
Orange! used to indicate the
presence of a potentially hazardous situation which,if
not avoided, could result in death or serious injury.
Yellow with safety alert symbol!
used to indicate the presence of a potentially
hazardous situation which, if not avoided, may cause
minor or moderate injury.
Yellow without safety alert symbol! used to indicate
the presence of a potentially hazardous situation
which, if not avoided, may result in property damage.
Green! used to indicate
operation or maintenance information.
Platform Components 1-1 Platform
How to Remove the Platform
1
Find the link to the ministry of tank
bottom,control cables.Recognize that the number of
the cable and position.
2
From the control of the tank bottom off cable.
3 Remove the bolt platform control box.Move machine
control box and kaiping aside. 4 Remove platform base
and arm the axid of a connection,and remove the
slider.
5 Remove the whole work platform.
