Nisca PR53FS, Руководство по эксплуатации

Страница: 50 / 57

?
The ink ribbon is finished
?
Replace with the fresh ink ribbon.
P.30
?
The ribbon type setting of the printer and the ribbon type actually
being used do not correspond.
?
Pull out the ribbon cartridge after pressing the
MENU/ Ribbon Change key and check the type of the ribbon in
the cartridge. If the type is correct, change the setting of the
operation panel to the correct one.
?
The ribbon cartridge has been taken out without pressing the
MENU/ Ribbon Change key while the ink ribbon is not used up to
the end.
?
The printer beco mes to error and normal printing is not possible.
Check the ink ribbon.
P.25
P.30
?
Ink ribbon is not set correctly.
?
Check whether the ink ribbon is correctly set in the cartridge.
?
Ribbon transport roller is dirty
?
Clean the roller.
?
Improper card is used.
If a card which is already printed with this printer is used,
the ribbon sticks to the card and card jam error will occur.
?
Peel off the ribbon from the card and roll up the ribbon2 - 3 turns.
If the ribbon is broken, use Scotch tape et c. to patch up and roll up.
It may require repairing depending of the condition.
?
The engagement teeth of the bobbin is broken by dropping etc.
?
Replace with the normal bobbin
If the take up bobbin is damaged, unwind the used ribbon or cut off
the wound up part of the ribbon, attach the end to the normal
bobbin and wind up to the next frame.
P.30
P.34
Ribbon Empty
? ?
-
? ?
Ribbon Type
Incorrect
? ?
-
? ?
Ribbon Wind up
miss
? ?
-
? ?