Nisca PR5350, Руководство по обслуживанию, Страница: 23 / 97

3.3.3 Description of Service Mode
(Adjustment Mode: printer adjustment menu)
Adjusting maximum optical density and print position etc.
Note: Do not make the value higher or lower than
you need. It may cause trouble.
*Optical Density (OD) Adjustment Menu
OD Adj. Color : OD Adjustment for color image
OD Adj. Black : OD Adjustment for Black
OD Adj. Clear : OD Adjustment for Clear (over coat)
Clear key : Make image lighter (Min. value :-7)
Exe key : Make image darker (Max. value :7)
*Pre-heat Adjustment Menu
Zero Adj. Color : Pre-heat Adjustment for color print
Zero Adj. Black : Pre-heat Adjustment for Black print
Zero Adj. Clear : Pre-heat Adjustment for Clear (over coat) print
Clear key : Decrement Value (Min. value :-7)
Exe key : Increment Value (Max. value :7)
According to a card. In case that color come out even there is no data transferred or color
do not come out well, then use this adjustment.
*Print position adjustment
Horizontal Adj. : Position adjustment for horizontal direction
0.085mm/digit (see figure below for adjustment direction)
Clear key : Decrement Value (Min. value :-50)
Exe key : Increment Value (Max. value :50)
*Print position adjustment
Vertical Adj. : Position adjustment for vertical direction
0.085mm/digit (see figure below for adjustment direction)
Clear key : Decrement Value (Min. value :-16)
Exe key : Increment Value (Max. value :16)
Vertical
Horizontal
+
- +
-
Card
Print