12
HOW TO ASSEMBLE
Do not connect power supply cord until the as-
sembly is completed.
1.
Mounting turntable platter
(1)
Insert your fingers into the two holes of the turntable platter
as shown in Fig. 1 and slowly mount on the motor shaft. For
removing the turntable platter pull it up in the same way.
Note: The magnetic coating surface (inside part of the rim)
must be handled with tare so as not to be injured.
(2)
After mounting the turntable platter, place the turntable mat
aligning the hole to the motor shaft.
2.
Attaching counterweight
Push in the counterweight at the rear end of tonearm as
shown in Fig. 2 with the stylus force scale facing front.
While pushing the counterweight, turn it in the arrow direc-
tion. After attaching, make sure that it moves back and forth
by turning it.
3.
Mounting the cartridge
When mounting a cartridge on this record player, follow the
instruction manual of the cartridge to be used as well as re-
ferring to Fig. 3 and following instruction.
Cartridges weighing 5g to 10g can be mounted with the use
of the attached head shell. Be sure to protect the stylus
from damage by leaving the stylus cover attached while
mounting.
(1)
Be sure to make correct connections. Follow the color cod-
ing on the lead wires (Fig. 3).
(2)
When fixing the cartridge, at first, lightly fix it with screws
so that it will move slightly. Adjust so that the head shell
and the cartridge are in parallel and in right angle (Fig. 4).
Securely fix the screws after positioning the cartridge in the
dimension shown in Fig. 5. At this position, a specified over-
hang can be obtained when mounted on the tonearm.
Note: When the cartridge is replaced, its weight will be different and
so will be the stylus force. Be sure to adjust the stylus force, an-
ti-skating and the aim lifter height.
It is easier if you replace cartridges readily mounted on a head
shell than to replace cartridge alone. Therefore it is recom-
mended to obtained a head shell together when you purchase
another cartridge. The combined weight of 14g to 19g of the
head shell and accessories is acceptable.
Fig. 1 Mounting turntable platter
Fig. 2 Attaching counterweight
Fig. 3 Mounting the cartridge in the head shell
