Nilfisk-Advance Condor XL, Руководство по обслуживанию

Страница: 44 / 233

&RQWURO6\VWHP
44
6HUYLFH0DQXDO±$GYDQFH&RQGRUŒ;/1LO¿VN(5
‡
Press the red Scrub Off switch to return to the previous menu without changing the
percentage value.
9. Turn the Key Switch to the off position. The new settings will be saved and remain in effect
until they are changed again.
&RQ¿JXUDWLRQ'LVSOD\0HQX
Note:
7KH&RQÀJXUDWLRQ'LVSOD\ZLOORQO\GLVSOD\WKHDFWLYHFRQÀJXUHGVHWWLQJVDQGIDXOW
FRGHV<RXFDQQRWPDNHDQ\FKDQJHVWRWKHPDFKLQHFRQÀJXUDWLRQIURPWKH&RQÀJXUDWLRQ
Display Menu other than clearing the fault codes. See the
&RQ¿JXUDWLRQ0HQX
section for
LQVWUXFWLRQVRQKRZWRFKDQJHWKHPDFKLQHFRQÀJXUDWLRQ
1. Press and hold the Emergency Flashers switch.
2. Turn the Key Switch to the run (on) position. Continue to hold the Emergency Flashers
switch until all the display panel lights turn off (approximately three seconds), then release
the switch.
7KHÀUVWOLQHRIWKH/&'ZLOOUHDG
CONFIGURATION DISPLAY
.
3. Press the Side Broom Up (
+
) and Down (
-
) switches to scroll through the displayed
menu items as shown on the following pages.
4. When the arrow is pointing to a menu item:
‡
Press the green Scrub On switch to display the next level of menu items.
‡
Press the red Scrub Off switch to return to the previous menu level.
5.
7XUQWKH.H\6ZLWFKWRWKHRIISRVLWLRQWRH[LWWKH&RQÀJXUDWLRQ'LVSOD\
PEDAL CALIBRATION
Place Pedal in Neutral
Neutral Deadband
Press and hold the Engine Speed switch, then turn the key switch on.
Indicates that the neutral position has been set after the
Scrub On switch is pressed. The bottom line displays the
resistance through the rotary sensor.
Selects the neutral deadband range - 2% to 15%
in 1% increments. The factory default is 3%.
Neutral Set
XXX ohms
2%, 3%, 4% . . . 15%