Nidek Medical Ice 900, Руководство оператора

Страница: 13 / 144

3
BEFORE USE : Configuration
1
Blocking arm
When the arm is slightly lowered by hand, blocking starts automatically.
Blocking can also be started by pressing the blocking start button on the Blocking screen.
The blocking pressure is 2.5 kgf.
Lens clamp
Holds the lens.
Lift the Lens clamp lever and place the lens with the convex surface up then lower the lever gently to hold the lens.
Lens table
Place the lens on the three pins with the convex surface up.
With the flexible lens holder system, the pin is adjusted to keep the lens front side horizontal when the lens is
clamped.
Reflection protective plate
The glass is for protecting the reflection sheet.
Be sure not to smudge the plate with dirt or fingerprints as it may affect to the instrument performance. When the
glass is smudged, clean the plate with a dry soft cloth.
Lens table (for Shape Imager)
Attach the lens table (for Shape Imager) to the instrument and place the demo lens or pattern.
Be sure not to smudge the table with dirt or fingerprints as it may affect to the instrument performance. When the
glass is smudged, clean the table with a dry soft cloth.
Small-diameter lens holder
When blocking a lens, if the lens cannot be held with the lens clamp as the demo lens is too small, use the
small-diameter lens holder to hold the demo lens.
Pilot lamp
Instrument startup LED indicator.
The brightness (Off, Dark, Light) can be selected with the parameter setting.
However, if “off” is set, the light still turns on temporarily when the power is turned on.
Right jog dial
Rotate the right jog dial to select a data and change numeric values on the screen.
Blocking system lever
When the lens table (for Shape Imager) is attached, use this lever to perform vertical and rotation movement
of the blocking system.
Lens clamp lever
Performs vertical movement of the lens clamp.
Lift the lens clamp lever and place the lens with the convex surface up then lower the lever gently to hold the lens.
Fixing pin (lens table)
When attaching the lens table (for Shape Imager), insert this fixing pin into the lens table hole.