Nice E Fit MP, Инструкции и предупреждения по установке и использованию

Страница: 9 / 76

5.11 - Total or partial deletion of memory
This procedure allows you to choose under point 05 the data that you want to delete.
Procedure performed with a transmitter memorized in “Mode I”
01. Keep the
n
key pressed and wait for the motor to perform 2 movements. Upon completion, release the key.
02. Keep the
s
key pressed and wait for the motor to perform 3 movements. Upon completion, release the key.
03. Keep the
n
key pressed and wait for the motor to perform 3 movements. Upon completion, release the key.
04. Keep the
t
key pressed and wait for the motor to perform 3 movements. Upon completion, release the key.
05. • To cancel the entire memory: Keep the
s
and
t
keys pressed and wait for the motor to perform five movements. Upon completion, release the keys.
• To delete only the memorized transmitters: do not press any key and wait until the motor performs five movements.
• To delete only the limit switch heights and intermediate heights: ATTENTION! - This deletion must be performed only when you want to adjust
the limit switch heights again, using a different procedure than the one used previously. Keep the
n
key pressed and wait for the motor to perform 5
movements. Upon completion, release the key.
Note – When performing the procedure, you can cancel it at any time by keeping the
n
and
t
keys pressed simultaneously for 4 seconds. Otherwise, do not press
any key and wait 60 seconds for the motor to perform 6 movements.
5
sec.
01
04
03 02
5
sec.
2 3
5
sec.
all
data
only
05
05
THE
END
“0”
“1”
“H”
05
THE
END
THE
END
5
sec.
5
sec.
5
5
sec.
5
5
3
3
ATTENTION!
This deletion must be performed only when
you want to adjust the limit switch heights
again, using a different procedure than the
one used previously. Whereas if you want to
adjust heights with the same procedure, it is
not necessary to delete them from memory.
EN
English – 8
END
END
END