12
5.Operation
You must use machine after you read and
understand the entire manual and its warning.
Before use, deflate the air in the tire and remove all
the weights attached on the wheel.
The operation of tire changer consists of
:
a
)
bead breaking
b)demounting tire c
)
mounting tire
We suggest the tire changer should be
equipped with pressure adjust device.
5.1Breaking bead
When break the bead, you should be very
careful. When the bead breaking pedal drives
the bead breaker arm to move fast and
forceful, the bead breaker arm will cause
danger and crash to everything in its moving
area.
Check whether the tire is deflated. If no, deflate the air in the
tire and close the clamping jaw completely.
When break the bead, if the clamping jaw at the
open position, it will be very dangerous to the
hand of the operator. During bead breaking
process, never contact your hand with the wall
of the tire.
Lean the wheel against the wheel guard (Fig5-1 M
)
, as
Fig5-2. Lean the bead breaker blade
(
Fig5-1 N
)
against the
bead 1cm from the rim. Note that the blade is leaned against
the tire not the rim. Step down the pedal
(
Fig5-1 J
)
,
move
the blade, when the blade moves to the limit of its travel,
release the pedal and rotate the tire slightly until the tire is
completely detached from the rim.
Fig 5-1
Spread the lubrication oil or the similar
grease on the bead. The lubrication oil
applied must be featured with non-toxic,
harmless and non-flammable. Not using
the grease will cause the serious damage to
the bead.
To avoid damaging the tube, you need to
position the core of the wheel at the right
side of the tool head with the distance of
10cm
(
Fig5-5
)
Содержание TC-1300
Страница 1: ...3456789 C61CN...
Страница 36: ...35...