NHProEquip TC-1300, Руководство пользователя

Страница: 7 / 36

6
jaw guide rail on the turntable to prevent the oxidization.
4. Installation
4.1Space requirement
When choose the installation site, you should make
sure it meets the forced safety work regulation.
The tire changer must be connected with the power supply
and air supply. Hence, we suggest to install the tire changer
near the power supply and air supply for the convenience
of correct use of all the parts of the machine If installed
outdoors, the machine should be equipped with the shelter
to prevent the rain.
4.2 Assemble the parts
4.2.1Assemble column
Before installation and commission, you should
carefully read the manual. The modification without
the permission of the manufacturer will cause the
damage to the machine.
The person to install and commission must have some
knowledge of electrical.
The operators must under the special train.
Before installation, you must carefully check the
equipment list. If you have any question,
immediately contact the dealer or our company. To
secure the smooth installation and commission, you
should prepare the following common tools:
2 pc monkey wrench（10″）, 1pc socket wrench, inner
hex spanner, 1 set of screw driver, 1pc hand hammer
and 1pc universal electric meter
4.2.2 Open the box
4.2.3 As per the instruction to open the box, open
the box. Remove the package material. Check if there
is not any damage during transportation and if the
spare parts are intact.
4.2.4 Take the package material from the working
field where to properly handle as per the local
laws and regulation.
4.2.5Assemble the column
Place the machine cabinet on the ground stably in
the working field. Open the accessory box. Take
out the rotation shaft assembly（Fig4-1 A）and
push-out shaft assembly（Fig4-2 B）and clean up
and spread the grease.