NF CA5350, Инструкция по эксплуатации

Страница: 31 / 110

2.3 Grounding and Power Supply Connection
CA5350 2-13
2.3 Grounding and Power Supply Connection

Grounding
Take the following precautions to avoid risk of electric shock.
Before connecting the device to the power supply, make sure the
protective grounding terminal is grounded.
The protective grounding terminal for
CA5350
is the grounding pin of
the three-pole power cord. Make sure you insert the power cord’s plug
into a three-pole power outlet with a protective grounding contact.

Power Supply
CA5350
operates with the following commercial power supply.

Voltage range : AC 100V/120V/220V/240V ±10%, not exceeding 250VAC
(Select the voltage with the power voltage selector switch
on the real panel)

Frequency range : 50 Hz/60 Hz ±2Hz

Overvoltage category : II
Maximum power consumption is 40VA.
The power switch of
CA5350
is located on the rear panel.
Make sure that the power switch is set to OFF before connecting the power cord.
After powering off the device, make sure to wait for at least five seconds before
powering on again.
The power code set can be used for disconnecting the product from AC power line in
case of emergency.
Maintain enough space around the inlet, to be able to remove the
connector of a power cord from the inlet. Use a power socket located
at convenient place with adequate space around so that the plug can
be removed from socket.

Fuse
The rated fuse of
CA5350
is as follows:
100V, 120V: Time-lag 1A
220V, 240V: Time-lag 0.5A
As for both, rated voltage is 250V and size is ø5.2 × 20mm.

Ensure that change settings of the voltage selector switch or
replace the fuse after pulling over the power supply plug.

Only use the fuse that with specified capacity.
WARNING
WARNING
WARNING