NF CA5350, Инструкция по эксплуатации

Страница: 21 / 110

2.2 Installation
CA5350 2-3
2.2 Installation
2.2.1 General Precautions for Installation
Take the following precautions to prevent damage to CA5350.

CA5350
is cooled by forced air-cooling. When you find that the fan
has stopped, turn off the power switch immediately and please
contact NF Corporation or one of our representatives. Using the
product with the fan stopped may increase the damage, thus makes
the repair impossible.

The
CA5350
must be installed horizontally (with the bottom panel
facing the floor). Using the device with the rear panel or side panel
facing downward (in the upright position) causes the device to be
toppled down easily, which leads to a danger.

Handling of the panel and case
When the case/panel surface needs to be cleaned, wipe it with a soft cloth. To remove
persistent stains, wipe with a soft cloth soaked with neutral detergent and wrung out.
Do not use any organic solvents like thinner or benzene, or any chemical cleaning cloth,
as they may cause the surface coating to deteriorate, tarnish, or peel off.
2.2.2 Installation Conditions
Install
CA5350
in a location that fills the following temperature and humidity
requirements.
Operating: 0 to +40°C, 5 to 85% RH
(where absolute humidity is 1 to 25g/m
3
, non-condensing)
Altitude: 2000m or less
Performance guarantee: 23±5°C
，
5 to 85% RH
(where absolute humidity is 1 to 25g/m
3
, non-condensing)
Altitude: 2000m or less
Storage: −10 to +50°C, 5 to 95% RH
(where absolute humidity is 1 to 29g/m
3
, non-condensing)
Do not install at the following places

Places with inflammable gases
Danger of explosion. Never install or use at such place.

Outdoors or place with direct exposure to sunlight or place near fire or heat source
Performance may decline and product may trouble.

Places with corrosive gases, moisture and dust, highly humid places
May result in corrosion, trouble and performance deterioration.

Near electromagnetic source or high voltage device or power lines
May result in malfunction of the product.

Places with lot of vibration
Noise increases, which may result in measurement error or malfunction.
CAUTION