Nexta Tech PRG-M24, Инструкция по эксплуатации

Страница: 8 / 16

6 - SETTING WORKING TIME OF MOTORS
Default: no time set
NOTE:
Before carrying out this procedure programme a remote control (see paragraph 5)
Also check that the motor stops when it gets to the limit and the letter “L” appears on the display (the limit is detected if
there is a mechanical stop or where there is a built-in limit switch).
If that does not occur, adjust the movement threshold with the VR1 trimmer “Sens.” (the trimmer adjusted full scale to “-”
disables the movement threshold).
To obtain non-manual operation via radio set the operation to automatic, Venetian or Open-Stop-Close (see paragraph
3.1).
PROCEDURE
STEP 1
Keep pressing and releasing the SEL key until the
«T.MOT.» LED comes on.
STEP 2
Press and release the SET button to confirm. The LED on
the display flashes.
STEP 3
By pressing and releasing the SEL key you can select value
"0" on the display
STEP 4
Press and release the SET button to start automatic programming.
The control unit will make a closing movement followed by opening
and closing cycles at the end of which the maneuver times will be
programmed.
ATTENTION: if the first movement is opening instead of closing, press
the SET button to interrupt the programming of the run and invert the
phases of the motor. Then repeat the procedure.
8
SOLE
NEVE
TEMP.
PIOGGIA
VENTO
T.MOT.
CODE
MOT.TYPE
SEL
Sens.
Rit. Neve
SET
SOLE
NEVE
TEMP.
PIOGGIA
VENTO
T.MOT.
CODE
MOT.TYPE
SEL
Sens.
Rit. Neve
SET
SOLE
NEVE
TEMP.
PIOGGIA
VENTO
T.MOT.
CODE
MOT.TYPE
SEL
Sens.
Rit. Neve
SET
SOLE
NEVE
TEMP.
PIOGGIA
VENTO
T.MOT.
CODE
MOT.TYPE
SEL
Sens.
Rit. Neve
SET