Nexta Tech PRG-M24, Инструкция по эксплуатации

Страница: 11 / 16

7.3 - SETTING TEMPERATURE SENSOR
Default: not enabled
NOTE
- The sensor works only if the operating mode is set at automatic, Venetian or Open/Stop/Close, see paragraph 4
When the sensor detects a temperature below 2°C, it puts the control unit into alarm mode to stop ice forming.
ALARM : the sensor detects a temperature below 2°C and the pergola is closed: then the control unit turns the pergola
slats to 4% of full opening and activates the snow contact (terminals 7 and 8) for a period from 30 minutes to 4 hours, that
can be set with the VR2 trimmer “Snow Delay”
ALARM NOT PRESENT/END OF ALARM : the temperature detected is above 3°C or a command is received
ALARM TEST: the control unit makes a brief opening movement followed by a brief closing movement. When the test is
completed the control unit will beep 4 times in confirmation.
PROCEDURE:
STEP 1
Keep pressing and releasing the SEL key until the
«Temp» LED comes on.
The display shows the current setting.
STEP 2
Press and release the SET button to confirm.
The LED on the display flashes.
STEP 3
By pressing and releasing the SEL key, select the value corresponding
to the setting you want, according to the following table.
DISPLAY NO. DESCRIPTION
d
Temperature sensor disabled
0 Temperature sensor test
y Temperature sensor enabled
E Exit
STEP 4a
Press and release the
SET key and the LED
on the display will stop
flashing.
STEP 4b
Press and release the SET key and the LED on the display
will stop flashing.
To carry out the test grasp the sensor between your fingers
so as to change the temperature detected by a few °C: the
control unit will make a brief opening movement followed
by a brief closing movement. When the test is completed
the control unit will beep 4 times.
NOTE: when the test is completed remember to activate/
deactivate the sensor to exit test mode.
d (disabled) 0 (test) y (enabled)
STEP 4c
Press and release the
SET key and the LED
on the display will stop
flashing.
When the sensor puts
the control unit into alarm
mode, the letter “A”
appears on the display.
11
SOLE
NEVE
TEMP.
PIOGGIA
VENTO
T.MOT.
CODE
MOT.TYPE
SEL
Sens.
Rit. Neve
SET
SOLE
NEVE
TEMP.
PIOGGIA
VENTO
T.MOT.
CODE
MOT.TYPE
SEL
Sens.
Rit. Neve
SET
SOLE
NEVE
TEMP.
PIOGGIA
VENTO
T.MOT.
CODE
MOT.TYPE
SEL
Sens.
Rit. Neve
SET