Nexta Tech PRG-M24, Инструкция по эксплуатации

Страница: 5 / 16

3 - SETTING UP CONTROL UNIT
The following functions are the default settings for the control unit:
- Manual management of a motor Ouvrir / Arrêter / Fermer
- Wired inputs enabled manually (operation cannot be set)
- No transmitter programmed
- No sensor enabled
Some functions can be set via the keys, LEDs and trimmers.
USE OF PROGRAMMING INTERFACE:
By using the SEL and SET keys you can move around inside the menus and change the various functions.
Each time you press the SEL key you move between LEDs. Each LED indicates a function (see following table for
specific functions).
To select the parameter press the SET key and then select the value that appears on the display with the SEL key (the
display’s LED flashes).
Confirm the selected value by pressing the SET key again (the display’s LED stays on).
After 20 seconds the control unit goes back into stand-by.
LED DESCRIPTION DEFAULT PARAGRAPH
Motor type Selecting motors and operating mode 1 motor, manual 3.1
Code Remote control management No associated remote control 3.2
T.motor Setting motor time No motor time 3.3
Wind Management of wind sensor Disabled 3.4
Rain Management of rain sensor Disabled 3.5
Temperature Management of temperature sensor Disabled 3.6
Snow Management of snow sensor Disabled 3.7
Sun Management of sun sensor Disabled 3.8
After making the connections automation is already in operation with manual commands via wire.
Display
Display led
SEL key
VR1 trimmer to adjust obstacle sensitivity
VR2 trimmer to adjust duration of snow
contact closure
SET key
5