7/10 - Safety instructions and user guide for the automatic pool cover
This document is the property of AS POOL - NextPool group and cannot be reproduced or communicated without our authorisation.
7
3
For the OPEN range, remove the cover or casing
or PVC cap on the motor side. Disconnect wires
1, 2, 3, and 4 of the motor cable in order to slide
it completely towards the shaft and remove the
unlocking ring.
4
For the BANC, remove the top cover and unscrew
the butterfly screw from the housing inside the
BANC Solar. Disconnect wires 1, 2, 3, and 4 of the
motor cable in order to slide it completely towards
the shaft and remove the unlocking ring.
5 For the IMM'Box and the DIVER with the motor
in a dry pit: remove the key between the shaft and
the motor casing or remove the motor.
6
For the IMMAX, IMMEO, DIVER with axial motor:
in the motor connection box located close to the
pool, disconnect the limit switch wires and the
power wires from the motor cable in order to slide
the motor cable completely towards the roller
shaft. Remove the pin blocker to access and lift the
unlocking pin.
7
Manually accompany the unrolling of the cover,
making sure that the motor cable does not jam.
8
Lock the safety mechanisms.
When commissioning the roller, a new adjustment
of the motor end of run stops will be needed.
9
"Waste Electric and Electronic Equipment"
(WEEE) is the subject of specific collection. It should
not be disposed of with your unsorted household
waste.
5. Maintenance advice
In the event of a malfunction or a repair preventing
the closure and the securing of the pool, take all
necessary measures to prevent the access to the pool
of children under 5 years old.
•
AS POOL only distributes its technical products via
a network of pool professionals which carries
out the installation and follow-up depending
on the specificities of the pool. AS POOL does not
communicate directly with pool owners.
•
Have the automatic cover serviced by a swimming
pool professional (we recommend your swimming
pool installer whose details are on the cover of this
manual), who will be able to contact our technical
assistance department. All spare parts must be original
spare parts in order to maintain our guarantee and the
cover’s compliance with the standard.
•
Each time it is commissioned, the cover should be
inspected to identify deteriorations that may
compromise its correct operation. A professional will
diagnose whether some slats need to be replaced.
•
Check that the upkeep advice is applied and that the
user carries out his checks regularly. Otherwise go over
them item by item.
•
Check that the coupling nuts are tightened, that the
stop ring and all the screws are present on the axis.
•
Check that the electric connections are tight and
operate correctly. Make sure there is no humidity or
oxidation on the cover's electric contacts (terminals in
the box, box connections, contacts of the key switch).
•
Check the condition and the ageing of the locking
mechanisms and the bungee cords used to retain the
PVC slats. Check that the straps are tight on the axis.
•
Check the correct operation of the filtering system, the
overflow and the water level regulator.
•
Carry out several rolling and unrolling tests to make
sure the cover is operational and especially to check
that the end of run stops are correctly placed.
•
When the system does not respond, your installer can
secure the pool by uncoupling the cover roller (except
for the ZITA model) and manually unrolling the cover
onto the pool before locking the safety mechanisms
on the pool cover. In this situation the pool cannot be
used until the cover is repaired.
•
Handling the uncoupling of the roller mechanism
should be read thoroughly before operation, with the
installation instructions.
1
Switch off the box.
2 Block the roller rotation while keeping the slats
rolled around it.
