11/24 - Installation instructions for the BANC D.sign above water automatic slatted safety cover
11
6.3 Adjustment of the end of rolling stop
Fig. 21
Use the key-operated switch to roll in the cover:
if the motor stops by itself before the entire cover
has been rolled in, adjust using the adjustment
screw on the pool side by turning it clockwise to
lengthen the run using the supplied blue hex key.
If the entire cover is rolled in before the motor
stops, unroll 1 m, then adjust the run using the
adjustment screw on the poolside by turning it anti-
clockwise to reduce the run, then begin the rolling
limit switch adjustment from the beginning.
6.4 Refitting the elements
Fig.23
Fig. 23
6.4.1 Refit the previously removed side casing using the 3
screws and the 2 plastic rivets.
6.4.2 Then refit the duckboards on the top and the upper
panel if the bench has one.
6. Limit switch adjustments
6.1 End of unrolling
Fig. 21
6.1.1 Find the 2 limit switch adjustment screws on the
motor located between the side casing and the
roller tube by pivoting the limit switch cover.
6.1.2 The screw on the pool deck side adjusts the end
of unrolling stop. Using the key switch, rotate the
motorised tube in the unrolling direction until the
motor stops automatically (this will determine the
end of unrolling position).
Fig. 21
6.2 Fixing the slat cover to the roller shaft
Fig. 22
6.2.1 Slide the black strap bars on the slats onto the
shaft then fix the straps under the black bars by
tightening the screws. Check that the gaps around
the cover in the pool are evenly spaced on either
side as soon as the rolling starts.
6.2.2 Correct the position of the strap fixtures if the
spacing is not even.
Fig. 22