Next generation 10/D/2010, Инструкции по установке и использованию

Страница: 20 / 35

TO REMOVE CHILD
Disengage seat belt tongue and buckle, remove the lap portion of seat
belt from the Lap Belt Positioning Clip and remove seatbelt from child.
When Booster is not being used, secure in position by engaging seat
belt over the booster seat.
TO REMOVE THE SEAT
Disconnect the upper anchorage
Attachment Clip and remove the seat.
38 39
Lift tab and unclip
Attachment Clip
Car's Anchor Fitting
USING WITH CHILD HARNESS IN BOOSTER SEAT MODE
Either Safe-n-Sound™Protecta PLUS™ Harness Series 220/2010 or Babylove™ EzyGo™ Harness Series
BL220/2010 are suitable for use with this seat.
VERSA TETHER™ compatible child harnesses are suitable with this child restraint and are sold separately. Refer
to the Harness instructions for full details of using and installing the Child Harness. When installing the harness,
connect its attachment clip to the
VERSA TETHER™ Catch on the Booster Seat's upper tether strap (as shown in
pages 42-43).
Use the extension strap (supplied with the Protecta Plus™) for all other instances to attach the harness to
anchor points in the luggage area such as the vehicle floor or ceiling.
This Booster Seat is not suitable for child harnesses that are not
VERSA TETHER™compatible.
Typically, the top shoulder slot or
next slot down will be used for
children using the Child Harness.
HEADREST POSITION:
Before installation ensure that the headrest is set to the correct height for your child (refer to page 30).
Headrest should be just above the child's shoulders. This will ensure that: The Child Harness shoulder straps
must be in the slots which are nearest to the child's shoulders, but not lower than the child’s shoulders.
BOOSTER SEAT WITH LAP-SASH SEATBELT BOOSTER SEAT WITH CHILD HARNESS
HOW TO USE HOW TO INSTALL WITH A CHILD HARNESS