12
13
HOW TO SET-UP
TO BE USED WITH A LAP-SASH OR LAP ONLY SEAT BELT IN THE BACK OF MOST CARS WITH FORWARD-FACING
SEATS.
To be used in forward-facing position by children whose shoulders are above the lower shoulder height marker
(approximately 6 months of age) until their shoulders reach the upper shoulder height marker (approximately
4 years of age).
Continue to use this infant restraint until the child reaches this limit.
Do not use this restraint until the child’s shoulders are above the lower shoulder height marker.
Infants are at risk of serious injury if they face forward too early.
Children are at risk of serious injury if they move to booster seats too early.
The child should not sit in this forward facing child restraint until their neck muscles are able to support their
head. Stay in a rear facing child restraint.
Regional Road Rules may prohibit the use of this restraint in the front seat until the child is 4 years of age.
Check your Regional Rules for exemptions.
• Fit the restraint firmly to the car seat and then fit the harness firmly to the child.
• A loose restraint or harness is dangerous.
• Do not use in a front seat, unless it has a child restraint anchorage point and your child is over 4 years of
age or in accordance with the applicable Road Rules in your region.
• Do not use the restraint without the Upper Anchorage Strap correctly attached.
• Do not use on any vehicle seat which faces sideways or rearwards.
• WHERE AN AIRBAG IS FITTED IN THE SEATING POSITION WHERE THE CHILD RESTRAINT IS TO BE FITTED,
FOLLOW THE VEHICLE MANUFACTURERS WARNINGS AND INSTRUCTIONS.
• IMPORTANT: Use lap or lap-sash seat belt and upper anchorage strap to attach the child restraint to the
vehicle seat.
• Ensure that the Lap Belt Positioning Clip is stored in the recess under the cover when the seat is used in
Toddler mode, so as to avoid injury or discomfort.
SUITABLE FOR USE
INSTALLATION AND USE OF RESTRAINT
For Toddlers who have reached the shoulder height limit on their infant restraint refer to pages
10-25. For Children who have reached the middle shoulder height marker and need to use a
booster seat refer to pages 26-53.
HARNESS ADJUSTMENT
To slacken the harness lift the harness adjuster lever
and pull both shoulder straps with the other hand.
HOW TO USE THE HEADREST
First remove both harness straps (Refer to page 16).
Then rotate lever down to loosen headrest clamp (
a
).
Slide the headrest up or down to suit the height of your
child, (refer to page 14 for toddler use or page 32 for
child use). In toddler mode, move the headrest so that
the bottom slots in the headrest line up with the top of
the child's shoulders. Then move the headrest so that
the slots line up with the nearest slots in the shell.
Ensure that the shoulder slots are correctly aligned
with the shoulders otherwise, move up to the next set
of slots in the shell. Rotate the lever upward to tighten
the headrest clamp (
b
). Then refit both harness straps,
ensuring that there are no twists and that each strap
is in the correct and matching slots in both the seat
shell and headrest (Refer to page 17).
UPPER ANCHORAGE
There needs to be an anchor fitting in the car behind the desired
seating position. Refer to your car owner’s manual for the
location of the anchor fitting. If the car is not fitted with a child
restraint anchor fitting then refer to page 59 for the installation
of the anchor fitting provided with this child restraint.
(a) To Release
Attachment Clip (hook)
Car's Anchor Fitting
(b) To Lock
Pull Straps
Lift and hold Harness
Adjuster lever up
TODDLER USE: WITH IN-BUILT HARNESS
TODDLER USE: WITH IN-BUILT HARNESS
Содержание 10/D/2010
Страница 34: ...66 NOTES 67 NOTES...
