Next generation 10/D/2010, Инструкции по установке и использованию

Страница: 31 / 35

PRE-INSTALLATION ANCHOR FITTING PRE-INSTALLATION ANCHOR FITTING
Anchorage Clip Cover
The shaded areas of this diagram illustrate the possible locations of the anchor fitting. Within
each shaded area is an anchor fitting showing the correct way to install the fitting. Ensure the
anchor fitting is aligned as illustrated unless stated otherwise in the vehicle owner’s handbook.
DISTANCE TO MEASURE TO
THE ANCHOR POINT
Correct engagement of attachment
clip to anchor fitting.
Adjustable Upper
Anchorage Strap
Front of Vehicle
Extension Strap distance to be measured.
Length 300mm (Use Safe-n-Sound part 0035)
Length 600mm (Use Safe-n-Sound part 0036)
Available from all major child restraint retailers. IF THE CAR IS FITTED WITH CHILD RESTRAINT ANCHORAGE
POINT
Locate the anchorage point behind the rear seating position.
(consult the car owners handbook for the location of the
anchorage point). The anchorage point should be directly behind
and central to the restraint. Remove thread plug from the parcel
shelf/floor/roof, etc. and install anchor bolt and fitting as shown
in Fig.1.
CAUTION: DO NOT OVERTIGHTEN ANCHOR BOLT.
OVERTIGHTENING MAY FRACTURE OR BREAK BOLT. MAXIMUM
TORQUE IS 20 N.M.
(14.75 ft.lb.)
Note: Minimum of five full turns of anchor bolt is required before
tightening force is applied.
IF THE CAR IS NOT FITTED WITH CHILD RESTRAINT ANCHORAGE
POINTS
For Sedans only
- Drill 9mm diameter hole in the parcel shelf on
the centre line of the seating position as shown in Fig.3. Before
drilling the hole, check the underside for accessibility. Install the
anchor bolt as shown in Fig.2.
For vehicles other than Sedans - In Australia, consult your
nearest child restraint fitting station or traffic authority
for vehicle inspection to find the best, correct position for
the placement of the anchorage point, and for the correct
attachment bolt length and use of spacers. In New Zealand,
consult the agent for the vehicle.
Note to Queensland purchasers: The installation of anchorage
points must be approved by authorised officers appointed by
Queensland Transport. Authorised officers can be sourced from
all Queensland Transport Customer Service and Queensland
Ambulance Service Centres.
UPPER ANCHORAGE FITTING
Attachment Bolt
Lock washer
Anchor fitting
Spacer(s) if
required
Vehicle metal
structure
Vehicle
trim
Attachment Bolt
Anchor fitting
Spacer(s) if required
Vehicle metal
structure
Reinforcing washer
(cone downwards)
Lock washer
Secure nut
UPPER ANCHORAGE FITTINGS
FOR SEDANS ONLY
Vehicle
trim
Fig.1.
Fig.2.
Front of Vehicle
61 60