Next generation 10/D/2010, Инструкции по установке и использованию

Страница: 13 / 35

Pull to
tighten
25 24
HOW TO USE HOW TO USE
C. Fit either harness buckle tongue into the
harness buckle followed by the other tongue
until a click is heard. Should the second
tongue not insert - press the red button
and reinsert the tongues. Ensure secure
engagement by pulling harness straps.
D. Ensure slack is removed from harness lap strap by pulling shoulder
straps then pull harness adjuster strap to adjust harness to a
comfortable but firm fit. See illustration above. Ensure that any
slack in harness straps is removed. Shoulder Harness Straps must
fit firmly to the child. A loose harness could result in serious injury
in an accident.
Do not use restraint if straps do not tighten and contact customer
service for repair. (See back page).
TO REMOVE TODDLER
Press red button on harness buckle then both harness tongues will be released.
Lift the shoulder straps from the child’s shoulders. Lengthen harness if needed.
Pull to remove slack from
harness lap strap
Shoulder
Strap
Harness
Lap strap
Crotch Straps
Click
TO REMOVE RESTRAINT FROM VEHICLE
A. Disengage seat belt tongue from buckle and remove from
restraint.
B. Release the stored strap and fully press Upper Anchorage
Strap Adjuster Button (1) while pulling Upper Anchorage
Strap (2) to slacken as shown right. In some vehicles
loosening of the Upper Anchorage Strap may be difficult. If
so, try pushing the restraint against the vehicle seat back
or slightly lifting the restraint to release the tension.
C. Disengage Attachment Clip from Anchor Fitting. The child
restraint is now disconnected.
Storage
Band
Attachment Clip and Cover
Car's Anchor
Fitting
1
2
Lift tab
and un-clip
CAUTION: A LOOSE HARNESS IS DANGEROUS.
Do not use restraint if straps do not tighten and
contact your local authorised service agent for repair.
TODDLER USE: WITH IN-BUILT HARNESS
TODDLER USE: WITH IN-BUILT HARNESS